Post photos of the game in question to be repaired

Replies to This Discussion

Permalink Reply by Spyridon on August 25, 2009 at 10:38am

I guess I start this thread off.

I have a Star Wars with a WG 6100 in it. The spot killer is on. I checked the x and y outs on the AVG board and found a problem with the values. I replaced the TL082 Amps and it corrected the problem...but I still have the spot killer on. Fuses are all good. I didn't see any bad solder joints, but I will be going back over it again.

I've got the WG 6100 vector monitor guide and will be going through it to figure out where to go next but I figured I'd try to generate some activity on this site (and speed up my fix)

Obligatory photo:

▶ Reply to This

Permalink Reply by Spyridon on August 28, 2009 at 2:13pm

Just an update on this, I have found the problem. Not only did I have a bad TLO82, but also the AVG chip was bad. Replaced it and the game works.

New problem:
Monitor gets blurry after a few minutes and eventually the picture just goes off.

▶ Reply to This

▶ Reply to This